Juice drink filling machine safety operation precautions

The use of beverage filling machines for beverage filling can greatly increase the filling efficiency, but it is necessary to pay attention to safety when operating the machine.

Before use, it is necessary to test run. Observe whether the running direction of the three-phase motor is correct, whether the filling machine pressure is normal, whether the motor and bearing are running normally, whether it needs to add lubricating oil, and also need to pay attention to the solidity of each part of the beverage filling machine. Whether the pieces are loose.

When the juice beverage filling machine is inspected before use, it can be used. In use, it is necessary to pay attention to whether the safety device function is normal. Before re-opening after each shutdown, it is necessary to check whether there are any abnormalities in the water tank, chain plate, conveyor belt, storage box, etc. At the same time, it is necessary to pay attention to whether the water source, power source and gas source are connected, and then check the equipment, then close the main Power QF, power indicator lights up, fault indicator, emergency stop indicator does not light, you can press the start button on the operation control box and the start switch of the filling station to start the overall operation of the machine. To stop the machine operation, you need to Press the stop button at the loading and control box, and turn off the main power after stopping.

In the whole juice beverage filling machine , the operation control box is used as the equipment for controlling the beverage filling machine. In the past, it was generally designed and adopted as a large-sized box design. This is mainly for safety reasons, and the staff can be guaranteed. There is no safety accident caused by operational control box performance problems when performing operational control.

1. During the production, the mechanical parts should be observed frequently to see if the rotation and lifting are normal, whether there is any abnormality, and whether the screws are loose or not;

2, check the ground wire of the equipment, the contact requirements are reliable; often clean the weighing platform; check the pneumatic pipeline for leaks, whether the air pipe is broken;

3. The gear motor is replaced with lubricating oil (fat) every year, check the chain tightly and adjust the tension in time;

4. If the use is stopped for a long time, the material in the pipeline should be drained;

5, do a good job of cleaning and sanitation, keep the surface of the machine clean, often remove the accumulated material on the scale body, pay attention to keep the inside of the electric control cabinet clean;

6. The sensor is a high-precision, high-sealing, high-sensitivity device. It is strictly forbidden to impact and overload. It must not be touched during work. It is not allowed to disassemble for non-overhaul.