Hand push scrubber use method

How should the hand-push scrubber be used? What should I pay attention to when using it? The following will give you a detailed explanation.

1, first read the instructions provided by the supplier, may be selected an appropriate power supply box and the box according to the push-type washing machine power, voltage.

When connecting the power supply, it should be noted that the 380V power supply cannot be out of phase, and the lack of phase will burn out the power of the push-type scrubber. In addition, the unstable power supply will cause the working pressure of the hand-pushing scrubber to be unstable, and the long-term use will cause the load of the motor to be too large to burn the motor.

Another point is that many customers are negligent, the cross-sectional area of ​​the power line is too small, which will make the current allowed to pass can not meet the current required by the motor, resulting in unstable working pressure of the hand-pushing scrubber. Therefore, choosing the right power cord and power supply box is an important task before the push-on scrubber is turned on. then. Select the appropriate inlet pipe based on its flow rate. If the inlet pipe is too thin, the flow will not be able to keep up. If the water intake is insufficient, the pressure will not reach the standard set by the hand-pushing scrubber. The long-term use will lead to increased wear of the seal and affect the service life of the hand-push scrubber. . The general industrial hand-push scrubber selects a 6- point inlet pipe.

2. After connecting the correct power and water source, there is still some work to be done before actually starting up.

First of all, the high-pressure pipe should not be connected to the water outlet of the hand-pushing scrubber. After the water source is turned on, the water will flow out from the water outlet. If there is no water, the inlet pressure is not enough or the check valve in the crank pump is blocked. However, the new machine check valve is generally not blocked, so it is necessary to solve the problem of water inlet pressure first.

After starting, start the equipment and let the hand-pushing scrubber run for about 1 minute without connecting the high-pressure pipe . Because the factory will test the machine and add antifreeze to the hand-push scrubber before leaving the factory. After a long period of transportation, the water in the pump body will be black. Therefore, the water in the pump must be drained first. Then connect the high pressure tube and the gun, and start the operation for about 1-2 minutes without connecting the nozzle . At this time, in order to squeeze out the air in the high-pressure pipe, it is possible to avoid the situation in which the high-pressure pipe is severely shaken during use.

After the above two steps are completed, you can use your hand-push scrubber to complete your work. The push-type scrubber can also be connected to different accessories during the process to complete some special cleaning work. For example, it can be used to clean the floor after connecting the washing plate, and can be cleaned after connecting the tank washer.

For more information on scrubbers, please visit: http://