1. Adjustment when the capping machine rolls different specifications of the bottle This machine can be used to roll 5-500ml vials and infusion bottles. When using any bottle of this specification, just put the bottle of this specification on the tray, one hand Hold the cross arm and loosen the nut on the left side of the cross arm with the other hand to lower or raise the cross arm until the cap and cap are about 20 mm. Tighten the nut and use the hex wrench with the strap. Close the bracket and lock the bracket. (Note) Pay attention to the position of the cap and the cap when tightening.
Second, the V-shaped branch adjustment The bottle is placed in the lower V-shaped branch, the two screws on the support block are loosened, and the bottle and the lower V-shaped block are moved together until the position of the capping head and the cap are aligned. , tighten the two screws on the V-block.
Third, the specific operation method of the capping machine 1. Put the bottle filled with liquid and put the lid on the lower tray, lean on the V-shaped branch block, hold the bottle with one hand, and pull the handle backwards with the other hand. At this time, the tray is lifted up by the bottle until the cap is pressed against the cap.
2. After the cap and the capping head are pressed, the caps of the three capping caps that are continuously rotated are rotated several times, and the cap is rolled tightly. (Note) The motor must run clockwise.
3. Push the handle forward so that the lid of the rolled cover returns to the original position with the tray, the whole operation process is completed, and the above operation can be repeated every time a bottle cap is rolled.
4. Adjustment of the capping head of the capping machine The machine is equipped with a plurality of capping heads, which can be selected according to the size of different bottle caps. Try it out before using it in the bottle.
1. If the cover is not tightly rolled, the capping nut can be unscrewed and the upper capping head can be unscrewed in the counterclockwise direction, and then the upper fixing nut is locked.
2, the lid is rolled too tight, there is a phenomenon of rotating the cap. The upper capping lock nut can be unscrewed and screwed clockwise into the upper capping head, and then the upper retaining nut is locked.
3, the bottom of the bottle cap is not tight, the eccentricity of the three rolling heads can be adjusted according to the actual situation. If the collection is too tight, there is a phenomenon of crushing the bottle, and the eccentricity of the three rolling heads can be appropriately adjusted.
Wetness Indicator Adult Diaper
Adult diapers are disposable urinary incontinence products, one of the adult care products, and a disposable diaper mainly suitable for incontinent adults.
Most products are flaky and shorts type. Use adhesive sheets to connect into a pair of shorts. The adhesive sheet also has the function of adjusting the waist size so as to fit different fat and thin body shapes.
Generally, the structure of diapers is divided into three layers from the inside to the outside. The inner layer is close to the skin and made of non-woven fabric; the middle layer is water-absorbent fluff pulp, added with polymer water-absorbing agent; the outer layer is an impermeable breathable film.
Tena Diapers,Adult Nappies,Adult Underpads,Adult Pull Up Diaper
Shandong Kangshun Daily Products Co., Ltd , https://www.centurybenifit.com